Table of Contents
Advertisement
Twist and pull to remove the knockout from the node.
b.
Install the dedicated iLO management port card into the node.
8.
If removed, install all rear I/O blanks
9.
Install any removed PCI riser cage assemblies.
10.
Install the node into the chassis
11.
Connect all peripheral cables to the nodes.
12.
Power up the node
13.
Enabling the dedicated iLO management module
To enable the dedicated iLO management module:
During the server startup sequence after installing the module, press F9 in the POST screen.
1.
The System Utilities screen appears.
Select System Configuration | iLO 4 Configuration Utility.
2.
The iLO 4 Configuration Utility screen appears.
("Install the rear I/O
("Installing a node into the
("Power up the
nodes" on page 32).
blank" on page 40).
chassis" on page 60).
Hardware options installation 131
Advertisement
Table of Contents
