Chassis Rear Panel Components - HPE Apollo 2000 User Manual

Item Description
Health LED (Node 4)
6
Power On/Standby button and
7
system power LED (Node 4)
UID button/LED
8
Power On/Standby button and
9
system power LED (Node 3)
1 When the LEDs described in this table flash simultaneously, a power fault has occurred. For more information, see
"Power fault LEDs (on page 15)."
2 Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the front I/O cable is disconnected.
3 If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health
status.

Chassis rear panel components

•
Four 1U nodes
Item
1
2
3
4
5
6
7
Status
1 Solid green = Normal
Flashing amber = System degraded
Flashing red = System critical
Solid green = System on
1 Flashing green = Performing power on sequence
Solid amber = System in standby
Off = No power present
1 Solid blue = Activated
Flashing blue:
•
•
•
Off = Deactivated
Solid green = System on
1 Flashing green = Performing power on sequence
Solid amber = System in standby
Off = No power present
Description
Node 4
Node 3
RCM module (optional)
Power supply 2
Power supply 1
Node 2
Node 1
3
2
1 flash per second = Remote management or firmware
upgrade in progress
4 flashes per second = iLO manual soft reboot sequence
initiated
8 flashes per second = iLO manual hard reboot sequence
in progress
2
Component identification 10