Flexiblelom 2U Node Riser Cage Assembly Option - HPE Apollo 2000 User Manual

Install the FlexibleLOM riser cage assembly.
9.
Do one of the following:
10.
Install the 1U left rear I/O blank
o
Install the single-slot left PCI riser cage assembly
o
option" on page 84).
CAUTION: To prevent improper cooling and thermal damage, do not operate the node unless
all PCI riser cages or rear I/O blanks are installed, and do not operate the node unless all PCI
slots have either an expansion slot cover or an expansion board installed.
IMPORTANT: If the PCIe riser cage assembly is not seated properly, then the server does
not power up.
Install the node into the chassis
11.
Connect all peripheral cables to the nodes.
12.
Power up the node
13.

FlexibleLOM 2U node riser cage assembly option

To install the component:
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
Remove 2U rear I/O blank
5.
("Install the rear I/O
("Installing a node into the
("Power up the nodes" on page 32).
("Remove the rear I/O
blank" on page 40).
("Single-slot left PCI riser cage assembly
chassis" on page 60).
blank" on page 39).
Hardware options installation 91