Siemens SINAMICS V90 Operating Instructions Manual page 115

You can also change the assignment of the digital output signal MBR and assign it to any
DO pin with one of the following parameters:
Parameter
p29330
p29331
Note
Refer to Section "Digital inputs/outputs (DIs/Dos) (Page 99)" for detailed information about
the digital outputs.
Wiring for the 200 V variant servo drive
The following diagrams show the examples when the brake is controlled through the motor
holding brake signal (Brake) of the 200 V variant servo drive.
Example 1:
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2017, A5E37208830-003
Range Factory set-
ting
1 to 14 2 (FAULT)
1 to 14 9 (OLL)
Unit Description
- Assignment of digital output 1
- Assignment of digital output 2
Connecting
4.7 Motor holding brake
115