Poe - KTI Networks KGS-1064-HP User Manual

Priority
DSCP
Auto-negotiation
Auto-negotiation status Auto-negotiation status identifies if auto-negotiation is currently enabled at the link
Auto-negotiation Capabilities

3.10.3 PoE

Status
Local Port
Power Type
Power Source
Power Priority
Tagged) is used if the device is using priority tagged frames as defined by IEEE
802.1Q-2003, meaning that only the IEEE 802.1D priority level is significant and the
default PVID of the ingress port is used instead.
Priority is the Layer 2 priority to be used for the specified application type. One of
the eight priority levels (0 through 7).
DSCP is the DSCP value to be used to provide Diffserv node behavior for the
specified application type as defined in IETF RFC 2474. Contain one of 64 code
point values (0 through 63).
Auto-negotiation identifies if MAC/PHY auto-negotiation is supported by the link
partner.
partner. If Auto-negotiation is supported and Auto-negotiation status is disabled, the
802.3 PMD operating mode will be determined the operational MAU type field value
rather than by auto-negotiation.
Auto-negotiation Capabilities shows the link partners MAC/PHY capabilities.
Description
The port for this switch on which the LLDP frame was received.
The Power Type represents whether the device is a Power Sourcing Entity (PSE) or
Power Device (PD).
If the Power Type is unknown it is represented as "Reserved".
The Power Source represents the power source being utilized by a PSE or PD device.
If the device is a PSE device it can either run on its Primary Power Source or its
Backup Power Source. If it is unknown whether the PSE device is using its Primary
Power Source or its Backup Power Source it is indicated as "Unknown"
If the device is a PD device it can either run on its local power supply or it can use
the PSE as power source. It can also use both its local power supply and the PSE.
If it is unknown what power supply the PD device is using it is indicated as
"Unknown"
Power Priority represents the priority of the PD device, or the power priority
associated with the PSE type device's port that is sourcing the power. There are three
-197-