KTI Networks KGS-1064-HP User Manual page 151

6. T he faults to be monitored are cable connections between ring ports and the switch members in a ring.
4 3 2 B
Other faults beyond these are not supported.
7. T he cabling of the backup link should be protected securely and has NO RISK for any failure.
4 3 3 B
8. W hen the backup link is activated, the faults should be investigated and repaired immediately.
4 3 4 B
Configuration
_____________________________________________________________________________________________________________________________ ______________________
C onfiguration
1 0 9 4 B
_ _____________________________________________________________________________________________________________________________________ _____________
7 2 9 B U
R ing Group #
1 0 9 5 B
R ing Port 1, 2
1 0 9 6 B
B ackup Port
1 0 9 7 B
R ing Group ID
1 0 9 8 B
7 3 0 B U
Save
Reset
___________________________________________________________________________________________________________________________________________________
N otes:
1 3 1 7 B
1. O ne switch provides two ports to support one redundant ring. As a slave switch, both ports are configured
1 3 1 8 B
<Ring Port>. To be a master of a ring, one port must be set to <Backup Port>.
2. O nly one backup port is configured among the member switches in a redundant ring.
1 3 1 9 B
3. O ne switched port can only be configured either Multi Ring enabled or RSTP enabled.
1 3 2 0 B
Description
Up to five redundant rings supported in one switch
Two ring ports are needed to support one redundant ring.
Check to specify the ring port as a backup port.
One unique ID is assigned for the associated ring group. The ring group ID should be
same for all switch members in the associated ring.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
-151-