KTI Networks KGS-1064-HP User Manual page 39

Read Community
Write Community
Engine ID
Trap Configuration
Trap Mode
Trap Version
Trap Community
Trap Destination Address
Trap Destination IPv6 Address Provide the trap destination IPv6 address of this switch. IPv6 address is in 128-bit
SNMP v3: Set SNMP supported version 3.
Indicates the community read access string to permit access to SNMP agent. The
allowed string length is 0 ~ 255, and the allowed content is the ASCII characters
from 33 to 126.
Note: This field only suits when SNMP version is setting SNMPv1 or SNMPv2c. If
SNMP version is setting SNMPv3, the community string will associated with SNMPv3
communities table. It provides more flexibility to configure security name than a
SNMPv1 or SNMPv2c community string. In addition to community string, a
particular range of source addresses can use to restrict source subnet.
Indicates the community write-access string to permit access to SNMP agent. The
allowed string length is 0 ~ 255, and the allowed content is the ASCII characters
from 33 to 126.
Note: This field only suits when SNMP mode version setting SNMPv1 or SNMPv2c. If
SNMP version is setting SNMPv3, the community string will associated with SNMPv3
communities table. It provides more flexibility to configure security name than a
SNMPv1 or SNMPv2c community string. In addition to community string, a
particular range of source addresses can use to restrict source subnet.
Indicates the SNMPv3 engine ID. The string must contain an even number between
10 and 64 hexadecimal digits, but all-zeros and all-'F's are not allowed. Change of the
Engine ID will clear all original local users.
Description
Indicates the SNMP trap mode operation. Possible modes are:
Enabled: Enable SNMP trap mode operation.
Disabled: Disable SNMP trap mode operation.
Indicates the SNMP trap supported version. Possible versions are:
SNMP v1: Set SNMP trap supported version 1.
SNMP v2c: Set SNMP trap supported version 2c.
SNMP v3: Set SNMP trap supported version 3.
Indicates the community access string when send SNMP trap packet. The allowed
string length is 0 ~ 255, and the allowed content is the ASCII characters from 33 to
126.
Indicates the SNMP trap destination address.
records represented as eight fields of up to four hexadecimal digits with a colon
separates each field (:). For example, 'fe80::215:c5ff:fe03:4dc7'. The symbol '::' is a
special syntax that can be used as a shorthand way of representing multiple 16-bit
-39-