Alarm Relay Output; Powered Via Poe Over Cat.5 (Kgs-1060) - KTI Networks KGS-1060 User Manual

2.6 Alarm Relay Output

Alarm relay output is provided for reporting failure events to a remote alarm relay monitoring system. The
replay output is provided with two contacts in the terminal block connector next Vdc interfaces.
Pin Assignments of the Alarm Relay output
AR+
AR
Use the provided 2P terminal plug for signal wiring and plug into the AR+/- contacts.
Alarm Events

Input power failure

Specific port link down (The specific ports can be configured by software.)

OPA alarm if optical power is higher than a upper limit setting or lower than a lower limit setting
Relay Logic
Normal: AR+ and AR- shorted
Alarm: AR+ and AR- open
Note: Be sure the voltage applied on AR+/- contacts is within the specification of 30VDC/1A max. or
120VAC/0.5A max.

2.7 Powered via PoE over Cat.5 (KGS-1060)

Port 2 is equipped with function of receiving power from connected PoE PSE device over Cat.5 cable. The
remote PoE PSE devices can be a mid-span PoE injector or end-span PoE switched port.
Alarm relay output positive () terminal
Alarm relay output negative (

) terminal
-18-