Management Vid (Mvid) Operation Rules; Ipv6 - KTI Networks KGS-1064-HP User Manual

2.1.2.1 Management VID (MVID) Operation Rules

The MVID setting restricts the ports that are allowed to communicate with the embedded system processor.
The allowed ports are limited in the member ports of the VLAN with MVID.
conditions that a management frame can reach the system process and the replied frame type sent by the system
processor. Refer to Section 2.14 for more configuration information of VLAN.
Management
Ingress port type
Unaware
C-port
S-port
S-custom-port

2.1.3 IPv6

Configuration
Auto Configuration
Address
Management
incoming packet type
Untagged
Untagged
C-tag tagged
Untagged
S-tag tagged
Untagged
S-custom-tag tagged
Description
DHCP Client Enable IPv6 auto-configuration by checking this box. If system cannot
obtain the stateless address in time, the configured IPv6 settings will be used. The
router may delay responding to a router solicitation for a few seconds, the total time
needed to complete auto-configuration can be significantly longer. Enable the DHCP
client by checking this box.
Provide the IPv6 address of this switch. IPv6 address is in 128-bit records represented
as eight fields of up to four hexadecimal digits with a colon separating each field (:).
For example, 'fe80::215:c5ff:fe03:4dc7'. The symbol '::' is a special syntax that can be
used as a shorthand way of representing multiple 16-bit groups of contiguous zeros;
but it can appear only once. It can also represent a legally valid IPv4 address. For
Conditions for acceptance
by the processor
PVID = MVID
PVID = MVID
VID = MVID
PVID = MVID
VID = MVID
PVID = MVID
VID = MVID
-19-
The table below lists the
Replied packets sent
by the processor
Untagged
Untagged
Untagged
Untagged
Untagged
Untagged
Untagged