2.17.2 Port Policing
Configuration
Port
Enabled
Rate
Unit
Flow Control
Save
Reset
Description
The port number for which the configuration below applies.
Controls whether the
policer
Controls the rate for the policer. The default value is 500. This value is restricted to
100-1000000 when the "Unit" is "kbps" or "fps", and it is restricted to 1-3300 when the "Unit"
is "Mbps" or "kfps".
Controls the unit of measure for the policer rate as kbps, Mbps, fps or kfps . The default value
is "kbps".
If flow control is enabled and the port is in flow control mode, then pause frames are
sent instead of discarding frames.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
is enabled on this switch port.
-127-