Upnp - KTI Networks KGS-1064-HP User Manual

Save
Reset

2.19 UPnP

Configuration
Mode
TTL
Advertising Duration
Save
Reset
Disabled: Neither frames transmitted nor frames received are mirrored.
Enabled: Frames received and frames transmitted are mirrored on the mirror port.
Note: For a given port, a frame is only transmitted once. It is therefore not possible
to mirror mirror port Tx frames. Because of this, mode for the selected mirror port is
limited to Disabled or Rx only.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
Description
Indicates the UPnP operation mode. Possible modes are:
Enabled: Enable UPnP mode operation.
Disabled: Disable UPnP mode operation.
When the mode is enabled, two ACEs are added automatically to trap UPnP related
packets to CPU. The ACEs are automatically removed when the mode is disabled.
The TTL value is used by UPnP to send SSDP advertisement messages. Valid values
are in the range 1 to 255.
The duration, carried in SSDP packets, is used to inform a control point or control
points how often it or they should receive a SSDP advertisement message from this
switch. If a control point does not receive any message within the duration, it will
think that the switch no longer exists. Due to the unreliable nature of UDP, in the
standard it is recommended that such refreshing of advertisements to be done at less
than one-half of the advertising duration. In the implementation, the switch sends
SSDP messages periodically at the interval one-half of the advertising duration minus
30 seconds. Valid values are in the range
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
-146-