Configuring Ip Address & Password Via Console And Telnet; Reference Manuals For Web, Console, Telnet Management - KTI Networks KGS-2422 Installation Manual

IP Address
IP Mask
IP Router
VLAN ID
SNTP Server
Save
Reset
Renew
Note:
1. If DHCP fails and the configured IP address is zero, DHCP will retry. If DHCP fails and the configured IP
address is non-zero, DHCP will stop and the configured IP settings will be used. The DHCP client will
announce the configured System Name as hostname to provide DNS lookup.
2. The IP addresses should be in dotted decimal notation.
3.3 Configuring IP Address & Password via console and telnet
[Password] setting command is in System command group.
>System password <password>
Parameters:
<password>: The allowed password string length is 0 to 31, and the allowed content is the ASCII
characters from 32 to 126.
[IP] command group is used to configure the switch's IP settings. The command syntax is:
>IP DHCP [enable|disable]
>IP Setup [<ip_addr>] [<ip_mask>] [<ip_router>] [<vid>]
Parameters:
<ip_addr>: IP address (a.b.c.d), default: Show IP address
<ip_mask>: IP subnet mask (a.b.c.d), default: Show IP mask
<ip_router>: IP router (a.b.c.d), default: Show IP router
<vid>: VLAN ID (1-4095), default: Show VLAN ID

3.4 Reference Manuals for Web, Console, Telnet Management

The following operation manuals are also provided separately for Console, Telnet and Web management:
Provide the IP address of this switch unit.
Provide the IP mask of this switch unit.
Provide the IP address of the default router for this switch unit.
Provide the managed VLAN ID. The allowed range is 1 through 4095.
Provide the IP address of the SNTP Server.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
Click to renew DHCP. This button is only available if DHCP is enabled.
↵
-29-