Korg PA1000 User Manual page 580

568| Effects for the Sounds, Voice, Guitar
b [R]Pre Delay [msec]
c [R]EQ Trim
Reverb Balance
d [R]PreLEQ Fc
Pre HEQ Fc
e [R]PreLEQ Gain [dB]
Pre HEQ Gain [dB]
GATE
f [G]Envelope Select
Src
g [G]Input Reverb Mix
Threshold
h [G]Polarity
i [G]Attack
Release
j Wet/Dry
Src
Amt
f: [G]Envelope Select
f: Src
g: [G]Input Reverb Mix
g: Threshold
The "[G]Envelope Select" parameter enables you to select whether turning
the gate on and off is triggered by the input signal level or controlled directly
by the modulation source. You can select from Off to Tempo for the Src pa-
rameter to specify the modulation source.
0...200 Sets the delay time of the reverb sound
and gate control signal
0...100 Sets the EQ input level
0...100 Sets the reverb effect balance
Low, Selects the cutoff frequency (low or
Mid-Low mid-low) of the low-range equalizer
High, Selects the cutoff frequency (high or
Mid-High mid-high) of the high-range equalizer
–15.0...+15.0 Sets the gain of Low EQ
–15.0...+15.0 Sets the gain of High EQ
D-mod, Input Switches between modulation source
control and input signal control
Off...Tempo Selects the modulation source that con-
trols the gate when Envelope Select is
set to D-mod
0...100 Sets the balance between the dry and
reverb sounds of the gate control signal
0...100 Sets the gate threshold level
+, – Switches between non-invert and invert
of the gate on/off state
1...100 Sets the attack time
1...100 Sets the release time
Dry, 1:99...99:1, Balance between the wet and dry signal
Wet
Off...Tempo See DMS (Dynamic Modulation Source)
–100...+100 Amount of modulation source