500|
Audio In/Out, Voice and Guitar Processor
Accessing the Master EQ
1
Go to the
Global > Limiter/Master EQ > Master EQ
Turning the Master EQ on/off
▪
Use the
On/Off
Programming the EQ
▪
Look at the results of any edit in the diagram. The diagram shows the EQ
curve. Its shape changes depending on the various parameter values.
▪
Use the
Input Trim
EQ. Excessive amount of signal may cause distortion when boosting the EQ
bands.
▪
Use the
Gain
responding band. Use it to make the frequencies stronger or weaker.
Band
All Bands
▪
Use the
Freq
ing band. Center it on the problematic frequency, or the harmonics you want
to emphasize or attenuate.
Band
Low
Mid-Low
Mid-High
High
button to turn the EQ on/off.
parameter to adjust the level of the signal entering the
parameter to change the emphasis or attenuation of the cor-
Value
-18...0...+18dB
parameter to change the center frequency of the correspond-
type of EQ curve
Shelving
Peaking
Peaking
Shelving
page.
Value
20Hz...1kHz
50Hz...10kHz
300Hz...10kHz
500Hz...20kHz