Table of Contents
Advertisement
396|
Customizing and editing the Sounds
Damper Mode
Repedaling
Programming the Resonance/Halo
You can program the Resonance/Halo effect that is enabled by the
Resonance/Halo
the Resonance/Halo that is enabled when pressing the Damper pedal down
when a note is already playing.
▪
Use the
Attack Time
Halo to reach the maximum level after the Damper pedal has been pressed.
Values (0...99) are relative to the current
▪
Use the
Release Time
Halo to fade out after the Damper pedal has been released. Values (0...99)
are relative to the current
▪
Use the
Volume Scaling
effect. Values (0...100%) are relative to the current level of the sound, as de-
termined by the sum of the Multisample Volume, Velocity value and current
Amp Env value. 0% is no volume at all.
Setting a key range without dampers
In an acoustic piano, the felt dampers can only dampen strings up to a cer-
tain note. Starting from that note (usually G6), it is as if the Damper pedal
was always pressed down, and the dampers removed from the strings.
▪
When the Damper is in
> From Note
notes are never dampened.
This parameter has no effect on the
Meaning
This mode acts as the Normal mode, but also enables the Damper
pedal effect when the pedal is pressed after the note has been re-
leased (Note Off). In this case, the Damper effect starts from the
current Release level, and decays slowly.
Do not use Repedaling in Sounds used by Style tracks.
Damper Mode (see above). These parameters only affect
parameter to set the time needed to the Resonance/
parameter to set the time needed to the Resonance/
Amp Env Release
parameter to set the volume of the Resonance/Halo
Normal
mode (see above), use the
parameter to choose the note (C#-1...G9) starting from which
Amp Env Attack
value.
Resonance/Halo
value.
No Note Off Range
mode.
Advertisement
Table of Contents
