Table of Contents
Advertisement
Oscillator triggering
Triggering Mode
controller.
Choosing the oscillator triggering mode
▪
Use the first
triggering the selected oscillator.
trigger Mode (What)
Note On
Note Off (VOn)
Note Off (VOff)
Last Note Off (VOn)
Last Note Off (VOff)
Natural Release
After Touch
Joystick Y+
Joystick Y-
is how the oscillator will start after pressing a key or a
OSC Trigger Mode > Mode
Meaning
The oscillator starts playing when a note is played.
The oscillator starts playing when a note is released. Note On
Velocity is considered.
This is useful to create sounds such as the 'click' that is heard when a
harpsichord note is released. In this case, set the Sustain parameter
to 0 (see the Amp > Amp EG page).
As the above, but Note Off Velocity is not considered.
The oscillator starts playing only when the last note of a chord or
legato sequence is released. Note On Velocity is considered.
As the above, but Note Off Velocity is not considered.
The oscillator starts playing when a note is released. Its amplitude
starts from the current amplitude level. If the sound's volume is al-
ready at zero, this oscillator is not retriggered.
The oscillator starts playing when an After Touch message with a
value of at least 90 is received. The Velocity value is the same as
the latest Note On message. The oscillator will stop playing when the
After Touch value falls back to zero.
Hint: This (like the following Triggers) is especially useful to trigger
harmonics or growls when a note is already playing.
As the above, but with the joystick, assigned as the Sound Controller,
pushed at least half-way forward (value 64). This control is equiva-
lent to a CC#01 (Modulation) Control Change message.
As the above, but with the joystick, assigned as the Sound Controller,
pulled at least half-way back (value 64). This control is equivalent to
a CC#02 (Breath Controller) Control Change message.
Editing the Sounds |391
pop-up menu to choose the event
Advertisement
Table of Contents
