Table of Contents
Advertisement
748|
Effects for the Sounds, Voice, Guitar
d
MIDI Sync
BPM
Base Note
Times
e
Depth
Src
Amt
f
Resolution
g
Output Level
Src
Amt
h
Wet/Dry
Src
Amt
a: Pre LPF
If a sampler with a very low sampling frequency receives very high-pitched
sound that could not be heard during playback, it could generate pitch noise
that is unrelated to the original sound. Set "Pre LPF" to On to prevent this
noise from being generated.
If you set the "Sampling Freq" to about 3 kHz and set "Pre LPF" to Off, you
can create a sound like a ring modulator.
f: Resolution
g: Output Level
If you set a smaller value for the "Resolution" parameter, the sound may
be distorted. The volume level may also be changed. Use "Output Level" to
adjust the level.
Off, On
When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
MIDI,
MIDI syncs to the system tempo; 40–300
40.00...
sets the tempo manually for this individ-
300.00
ual effect
Selects the type of notes that specify the
...
LFO speed
x1...x32
Sets the number of notes that specify the
LFO speed
0...100
Sets the depth of the sampling frequency
LFO modulation
Off...Tempo
Selects the LFO modulation source of the
sampling frequency
–100...+100
Sets the LFO modulation amount of the
sampling frequency
4...24
Sets the data bit length
0...100
Sets the output level
Off...Tempo
Selects the modulation source for the
output level
–100...+100
Sets the modulation amount of the out-
put level
Dry, 1:99...99:1,
Balance between the wet and dry signal
Wet
Off...Tempo
See DMS (Dynamic Modulation Source)
–100...+100
Amount of modulation source
Advertisement
Table of Contents
