Table of Contents
Advertisement
Set the modulation intensity
▪
While in the
FX Edit
(Amount)
parameter to set the intensity of modulation. This is an offset to
the normal value received from the source.
Feeding the master effects back to the MFX1 input
Master effects are set in parallel, but you can set them in a serial chain by
sending the output of the
processor. This is useful, for example, to send a delay into a reverb.
▪
While in the
Master Effects > FX A/B
the amount of the MFX2 signal to be sent back to the MFX1 processor.
page (for both the insert or master effects), use the
MFX2
processor back to the input of the
page, use the
to FX1
The effects |555
Amt
MFX1
parameters to set
Advertisement
Table of Contents
