Korg PA1000 User Manual page 664

652| Effects for the Sounds, Voice, Guitar
f Horn/Rotor Balance Rotor, 1...99, Horn
Manual SpeedCtrl
g Horn
Acceleration
Horn Ratio
h Rotor
Acceleration
Rotor Ratio
i Mic Distance
Mic Spread
j Wet/Dry
Src
Amt
a: Sw
This parameter determines how to switch on/off the overdrive via a modula-
tion source.
When "Sw" = Toggle, overdrive is turned on/off each time the pedal or joy-
stick is operated.
Overdrive will be switched on/off each time the value of the modulation
source exceeds 64.
When "Sw" = Moment, overdrive is applied only when you press the pedal or
operate the joystick.
Only when the value for the modulation source is 64 or higher, the over-
drive effect is applied.
Sets the volume balance between the
high-range horn and low-range rotor
Off...Tempo Sets a modulation source for direct
control of rotation speed
0...100 Sets how quickly the horn rotation
speed changes
Stop, 0.50...2.00 Adjusts the (high-frequency) horn ro-
tation speed. Standard value is 1.00.
"Stop" stops the rotation
0...100 Sets how quickly the rotor speed
changes
Stop, 0.50...2.00 Adjusts the (low-frequency) rotor ro-
tation speed. Standard value is 1.0.
"Stop" stops the rotation
0...100 Distance between the microphone and
rotary speaker
0...100 Angle of left and right microphones
Dry, 1:99...99:1, Wet Balance between the wet and dry sig-
nal
Off...Tempo See DMS (Dynamic Modulation Source)
–100...+100 Amount of modulation source