686|
Effects for the Sounds, Voice, Guitar
g
Mid1Cutoff [Hz]
Q
Gain [dB]
h
Mid2 Cutoff [Hz]
Q
Gain [dB]
i
Direct Mix
Speaker Simulation
j
Wet/Dry
Src
Amt
a: Wah
The Wah parameter switches the wah effect on/off.
a: Sw
This parameter sets how the wah effect is switched on and off via the modu-
lation source.
When "Sw" = Moment, the wah effect is usually turned off. It is turned on
only when you press the pedal or operate the joystick.
When a value for the modulation source is less than 64, "off" speed is
selected, and when the value is 64 or higher, "on" is selected.
When "Sw" = Toggle, the wah effect is switched between on and off each
time you press the pedal or operate the joystick.
The switch will be turned on/off each time the value of the modulation
source exceeds 64.
b: Wah Sweep Range
b: Wah Sweep Src
This parameter sets the sweep range of the wah center frequency. A nega-
tive value will reverse the direction of sweep. The wah center frequency can
300...10.00k
Sets the center frequency for Mid/High
EQ 1 (peaking type)
0.5...10.0
Sets the band width of Mid/High EQ 1
–18...+18
Sets the gain of Mid/High EQ 1
500...20.00k
Sets the center frequency for Mid/High
EQ 2 (peaking type)
0.5...10.0
Sets the band width of Mid/High EQ 2
–18...+18
Sets the gain of Mid/High EQ 2
0...50
Sets the amount of the dry sound mixed
to the distortion
Off, On
Switches the speaker simulation on/off
Dry, 1:99...99:1,
Balance between the wet and dry signal
Wet
Off...Tempo
See DMS (Dynamic Modulation Source)
–100...+100
Amount of modulation source