Conference Control - Huawei 9000 VCT V100R011 Administrator's Manual

HUAWEI 9000 HD Video Terminal
Administrator Guide
About This Chapter
During a multipoint conference, you can control the video and audio of the participating sites
using conference control functions.
A conference can have only one chair site at a time. Another site can become the new chair site
only after the current chair site releases its chair control rights.
If a conference is held with a built-in MCU, the conference control functions listed in
6-1
Table 6-1 Terminals and corresponding conference control functions
Terminal
ViewPoint 9039 with
a built-in MCU
ViewPoint 9036 with
a built-in MCU
HUAWEI VP9039A
with a built-in MCU
ViewPoint 9039S
with a built-in MCU
HUAWEI VP9036S
with a built-in MCU
Issue 09 (2012-09-03)
are available to the terminal whose built-in MCU is being used.

Conference Control

Functions Available to the
Terminal Whose Built-In
MCU Is Being Used
Functions to call sites,
disconnect sites, broadcast sites,
stop broadcasting sites, enable or
disable chair control, end a
conference, set continuous
presence, use default continuous
presence, broadcast continuous
presence, enable or disable voice
activation, and lock or unlock a
conference
Besides the preceding
conference control functions, the
functions to view sites and view
continuous presence are also
available.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6
Conference Control
6 Conference Control
Conference Control
Functions Available to the
Other Participating
Terminals
Function to request chair control
rights
Functions to request chair
control rights, set continuous
presence, view sites, and view
continuous presence.
Table
103