Huawei 9000 VCT V100R011 Administrator's Manual page 109

HUAWEI 9000 HD Video Terminal
Administrator Guide
Parameter
Number
Type
Rate
Line port
Country/Region code
Area code
IP address
URI
Step 3 Select Save.
----End
Creating a Group
If certain sites join a conference regularly, they can be defined as a group.
Procedure
Step 1 On the Address Book screen, select Create Group to display the Create Group screen.
Step 2 Enter a name for the group in the text box. The name cannot consist of only digits.
Step 3 Select the sites to be added to the group from the address book. Each selected site is marked
with a tick (√) before the site name and all the sites that are added to the group appear in the site
list.
Issue 09 (2012-09-03)
Description
This specifies the site number used to make calls between sites.
l IP, SIP, E1/T1/4E1, and H.323 Phone site numbers are allocated
by the videoconferencing service provider.
l PSTN site numbers are telephone numbers.
This specifies the line used by the terminal to access the
videoconferencing network.
l If Type is set to IP, the terminal uses the protocol set for
Preferred IP protocol.
l For Cisco TelePresence sites, you must select SIP as the line
type.
This specifies the rate supported by the terminal over the
corresponding access line used by the site.
It is recommended that you select the highest rate.
This specifies the line used by the terminal to communicate with the
site. This parameter is valid for E1 sites.
This specifies the country or area where the site is located.
This specifies the area code of a local ISDN site's conference line.
Set this parameter based on the country/region configured for the
site.
This specifies the IP address of the site.
This specifies the site's Uniform Resource Identifier (URI). For
example, abcd@huawei.com.
NOTE
This parameter is available only when Type is set to IP, H.323, or SIP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Initiating a Conference
97