990DSL
Users Guide
3.
If you supplied the correct gauge and temperature information in RFL
Setups prior to running the test, press A(
4.
If the correct gauge and temperature were not entered into Setups prior to
the test, you can enter them now. Press either D(
gauge and temperature information, or C(
gauge section information. When finished, press M, then A(
).
Fault
The relevant distances are displayed, as shown in Figure 4-15.
Figure 4-15. Two-Wire RFL Test Results: Distance to Fault
5.
If you want to obtain a second reading with the test leads connected to the
same pair, press D(
nulling process without again measuring fault resistances.
4-26
Repeat Fault Null
Distance to Fault
Setups
Multiple Gauge
). The CopperPro repeats the
).
) to enter single-
) to enter multi-
Distance to
acy24s.eps