Running A Loop Current & Ground Ohms Test - Test Equipment Depot 990DSL User Manual

990DSL
Users Guide
Running a Loop Current & Ground Ohms Test
1. From the POTS Toolbox, select
•
If the T-R DC Voltage measured was not Idle POTS as specified
in DCV Setups, the CopperPro displays a message asking you
whether or not to proceed, to avoid disruption of a possible non-
POTS service.
•
If you select
voltage to yield a meaningful measurement, the CopperPro
displays a
•
Otherwise, the CopperPro displays a result screen listing the
three test results.
2. Press the desired function softkey to view continuous test results for
any of the three tests.
4-52
Loop Cur. & Gnd Ω
to continue, and there is insufficient T-R
Yes
message.
No T-R Voltage
, and press K.