Typical Setup Menu - Test Equipment Depot 990DSL User Manual

990DSL
Users Guide
Setups - VF Noise
Beneath the generic setup parameters is a second group of setup parameters.
The parameters in this group are specific to the selected test. Look at the
screen, which is shown in Figure 3-3. The four parameters on
Setup-VF Noise
the bottom of the screen apply to the VF Noise test only. For descriptions of
the setup parameters for a particular test, refer to the table in the setup section
for that test.
3-6
Facility Cable No.
Pair / Terminal No. - 1001
CopperPro Pair No. - 1
Term. Impedance
Measurement Filter - C-Message
Nm Pass Thresh.
PI Pass Thresh.
Edit
Figure 3-3. Typical Setup Menu
- NPG5804
- 600 Ohms
- ≤ 20 dBrn
- ≤ 80 dBrn
Restore
Defaults
acy07s.eps