990DSL
Users Guide
Manually Controlling a Far-End Terminator
It may often be necessary to manually control a Terminator (or Terminator
Emulator) from the testing CopperPro to run individual tests on the pair, rather
than an Auto-Test, for more detailed fault analysis.
To control the Terminator via manual commands, do the following:
1.
From the Terminator VF Auto-Test Selection screen (Figure 4-32), press
D(
Manual Commands
The
Manual Term. Commands
2.
Select the desired
and the time
The CopperPro signals the Terminator to apply the selected termination
for the selected time, and then displays a
3.
Press M, and run the appropriate CopperPro tests for the selected
termination or tone.
4-72
).
Terminator Function
that the function will be applied, and press K.
Duration
screen is displayed.
(refer to the list in Table 4-19),
Termination Applied
message.