Table of Contents
Advertisement
2.
Select the desired test in the Dial-Up Test Toolbox shown in Figure 4-30,
and press L. The
3.
Press D(
Setups
4.
Select the desired Dialing parameters, listed in Table 4-14.
5.
Press M twice to return to the Dial-Up Test Toolbox.
Table 4-14. Dial-Up Test Setup Parameters
Setup Parameter
Dialing Mode
Start Mode
Centrex Mode
Centrex Prefix Digit
Feature Disable Prefix
Dialtone Detection
DTMF Duration (digit on / off times)
Running a Dial-Up Test
This section describes each Dial-up Test and shows you how to run it. Unless
otherwise indicated, follow this procedure to run a test in this group:
1.
Select
Dial-up Tests
2.
Select the desired Dial-Up test from the Dial-Up Toolbox, and press L.
The
Select Dialing Mode
POTS Testing and Fault Location
Select Dialing Mode
) to display the
Setups – Dial-up Tests
in the POTS Toolbox, then press L.
screen is displayed.
Dial-Up Test Group
screen is displayed.
Setting (default in bold)
Tone or Pulse Dialing
Loop or Ground Start
Disabled or Enabled
None or user entry (ex.: 9)
None or user entry (ex.: *82)
Enabled or Disabled
50 ms
(Range = 50 to 250)
4
screen.
4-55
Advertisement
Table of Contents
