Configuring The Serial Port; Creating A Custom Header For Test Result Files - Test Equipment Depot 990DSL User Manual

Configuring the Serial Port

If you want to print, download and upload files, or operate the CopperPro
remotely, you need to enable communications between the tester and an
external PC or printer.
To configure the tester's serial port for communications with a PC application
or serial printer, complete the following:
1. Press > then O to display the
2. Select
RS232 Port Setup
3. The
RS-232 Port Setup
the
Baud Rate
The baud rate is pre-configured at 38.4 kb/s for PC uploading and
downloading operations. Printer baud rates are internally preset for
the Seiko DPU-414 and DPU-411 printer choices.
4. To change the information on this screen, complete the following for each
parameter:
a) Position the cursor on the parameter, then press A(
b) Press G until you display the desired choice.
c) Press L to save your selection.

Creating a Custom Header for Test Result Files

You can create a custom header for your test result files. The purpose of the
header is to identify the operator, company name, test site, and job number.
When you view or print a test report, the information that you supply in the
following procedure can be selected to appear in the header of the file. This
information applies to all of your saved result files until you change it.
To create a header, follow these steps:
1. Press > then O to display the
Setting Up and Operating the CopperPro
USER OPTIONS
. Press L.
screen is displayed. The cursor is positioned on
parameter.
Note
USER OPTIONS
Configuring the Tester
menu (Figure 3-4).
).
Edit
menu (Figure 3-4).
3
3-17