Table of Contents
Advertisement
990DSL
Users Guide
Table 5-5. ADSL Auto-Test Setup Parameters
Parameter
ADSL Standard
Noise Measurement Filter
2.
Change the Setup parameters, if desired.
•
ANSI: Runs a frequency sweep of the full ADSL spectrum (8 kHz to
1104 kHz), with a data encoding limit of 15 Bits / Tone.
•
G.Lite: Runs a truncated sweep (8 kHz to 552 kHz), with a maximum
data encoding limit of 8 Bits / Tone.
Running an ADSL Auto-Test
1.
From the XDSL Toolbox, select
The
ADSL Auto-Test
2.
Connect the Sending and Receiving Units as shown in the diagram.
3.
If the "Sending Unit" is another CopperPro, press A(
press K.
3.
If the "Sending Unit" is a TN2100 "Terminator", simply turn it on.
4.
On the "Receiving Unit", select B(
5-28
Setting (default in bold)
ANSI (Full) or G.Lite
G (ADSL) or None, E (ISDN BR), F (HDSL)
ADSL Auto-Test
connection screen is displayed.
Receiving Unit
and press L.
), then
Sending Unit
)and press K.
Advertisement
Table of Contents
