Auto-Test Setup Menu
To display the setup menu for an Auto-Test, do the following:
1.
From the
Main
Test.
2.
Press D (
Setups
The
menu for the Auto-Test you selected is displayed.
Setups
Toolbox Test Setup Menu
To display the setup menu for a test in a toolbox, do the following:
1.
From the
Main
A menu of tests in the selected toolbox is displayed.
2.
Select the test that you want to set up. Then, press D(
The
menu for the test is displayed.
Setups
Generic and Test-Specific Setup Parameters
Figure 3-3 shows a typical setup menu for a toolbox test (VF Noise). Every
setup menu has two groups of parameters. At the top of the screen is the first
group, which consists of three generic parameters (described in Table 3-1).
The parameters are considered "generic" because they apply to all of the
CopperPro's tests.
You can change the value of a generic parameter from any setup screen (see
"Editing the Setup for a Test"). Just be aware that when you save the change, it
is stored in the tester's memory and applies to every CopperPro test.
Setting Up and Operating the CopperPro
menu (Figure 3-1), press H to select the desired Auto-
).
menu, press A(
POTS
), B(
), or C(
XDSL
Setups
3
The Menus
).
TDR
).
3-5