Table of Contents
Advertisement
990DSL
Users Guide
3.
Enter the length of the first section (five digits maximum, with no
commas), using the same units of measure (feet or meters) selected for the
Language configuration, then press L.
4.
PressG to move the cursor to the Section 1
5.
Press A(
Edit
6.
PressG to move the cursor to the
7.
Press A(
Edit
section or
if it does not. Then, press L.
N
8.
PressG to move the cursor to the
9.
If the Section 1 length entered is the actual known distance to the strap,
press F or H to select
10. PressG to move the cursor to the Section 2
11. Repeat Steps 2-7 until you enter information for all of the sections. When
you finish, press M to return to the
It is important to make sure that the last section that you enter
contains the strap position. If an "
message is displayed when you press theM key to exit the Multi-
gauge Entry screen, it is because the sum of the entered lengths is
shorter than the Distance-to-Strap length measured by the
CopperPro. In this situation, first verify that the entered
information is correct. If so, increase the length you entered
Gauge
for the last section. This change does not affect the accuracy of the
results, but allows agreement between the entries and measurements.
Deleting or Inserting a Wire Gauge Entry
To delete the information in a complete Section number line, select the desired
section using F or H, then press C(
To insert a section, position the cursor to the section above which you want to
add a line, and press B (Insert Section).
4-28
), press F or H for the desired gauge, then press L.
), and press F or H to select
. Otherwise select
Y
Gauge
field.
Load Coil
if a load coil terminates the
Y
field.
Strap Dist.
and press L.
N,
Length
results screen.
RFL
Note
Insufficient Length Entered
).
Delete Section
field.
field.
"
and
Length
Advertisement
Table of Contents
