Table of Contents
Advertisement
990DSL
Users Guide
The POTS Toolbox
The POTS Toolbox includes the same tests that are available in the Auto-Test
(see Table 4-1) as well as other fault location tests. This section introduces the
POTS toolbox tests, shows you how to run them, and describes their results.
Starting and Stopping a Test in the POTS Toolbox
•
From the
Main
(Figure 4-3). Press an arrow key to select the desired test, then press K.
OR
•
Display the setup menu for the desired test (see "Displaying a Setup
Menu" in Chapter 3), then press K.
To stop a running test, press K.
Voltage Test
The Voltage test gives you a "snapshot" measurement of AC and DC voltages
on each leg of a pair. The test can identify hazardous voltage, an idle or busy
POTS line, a Special Service circuit "footprint", or a cross-to-battery fault.
4-8
menu, press A(
POTS
Figure 4-3. POTS Toolbox
) to display the POTS toolbox
acy14s.eps
Advertisement
Table of Contents
