Table of Contents
Advertisement
Running a VF Loss Test
To run a VF Loss test, complete the following:
1.
Select
VF Loss
A connection diagram is displayed, as shown in Figure 4-26:
Figure 4-26. Connection Diagram for the VF Loss Test
2.
Connect the far end sending unit as shown in the diagram.
3.
Select A(
Single Tone)
OR
4.
Select B(
CopperPro SmartTone
5.
Instruct the sending unit to send the tone or tone-set, then press K.
POTS Testing and Fault Location
from the POTS Toolbox, then press L.
if the sending unit is to send a single frequency.
The POTS Toolbox
) if the sending unit is a CopperPro.
4
acy108s.eps
4-45
Advertisement
Table of Contents
