Table of Contents
Advertisement
990DSL
Users Guide
Top Connector Panel
The top connector panel has five 2 mm test lead connectors. These connectors
are color-coded for easy identification. The test lead connectors are identified
in Figure 2-1 as follows:
A Tip test lead (black)
B Ring test lead (red)
C Ground test lead (green)
D Tip 1 test lead (yellow)
E Ring 1 test lead (blue)
Side Connector Panel
The side connector panel is protected from rain by a tethered plug that is
attached to the holster. This panel has the following components, which are
identified in Figure 2-1:
•
RS-232 port (item A)
A nine-pin male D-Sub connector with locking nuts. The RS-232 port and
the supplied RS-232 cable are needed when you download programs from
a PC to the tester and when you control the tester remotely from a PC.
With a printer cable connected, the RS-232 port enables you to print serial
data.
•
DC power jack (item B)
A barrel jack that is used to power the tester externally and charge the
battery. This jack accepts a 12-15 VDC center-positive voltage that is
provided either by the supplied AC power supply or by the optional
Vehicle Power Cord.
2-6
Advertisement
Table of Contents
