Setting The Welding Parameters - Fronius TPS 320i Operating Instructions Manual

15
The selected filler metal and associated characteristics per process will be saved.
Setting the weld-
ing parameters
1
2
3
The value of the welding parameter is displayed as a horizontal scale:
e.g. feeder command value (wire feed speed) welding
parameter
The value of the selected welding parameter can now be changed.
4
The adjusted value of the welding parameter is applied immediately.
If one of the welding parameters "feeder command value", "sheet thickness", "welding cur-
rent" or "welding voltage" is changed during synergic welding, the other welding parame-
ters are immediately adjusted accordingly.
5
6
Press "Store"
(or press the adjusting dial)
1
Select the "Welding" button in the left-hand ribbon
Select the desired welding parameter by turning the adjusting dial
Press the adjusting dial to change the welding parameter
Turn the adjusting dial to change the welding parameter
Press the adjusting dial to call up the welding parameters overview
Adjust the process parameters accordingly to make user- or application-specific set-
tings on the welding system
3
4
2
67