Tig Welding - Fronius TPS 320i Operating Instructions Manual

TIG welding

1
IMPORTANT! For optimum welding results, the manufacturer recommends performing an
R/L alignment when starting the device for the first time and when any changes are made
to the welding system.
2
3
An overview of the welding processes is displayed:
-
-
-
-
-
-
-
-
4
The welding voltage is connected to the welding socket with a 3-second time lag.
5
The TIG welding parameters are shown.
90
CAUTION! Risk of injury and damage from electric shock. As soon as the mains
switch is in the "I" position, the tungsten electrode of the welding torch is live.
Make sure that the tungsten electrode does not touch any persons or electrically
conductive or earthed parts (e.g. housing, etc.).
Move the mains switch to the "I" position
5
2
Select the "Welding process" button in the left-hand ribbon
Select the "Process" button in the right-hand ribbon
MIG/MAG Pulse-Synergic
MIG/MAG Standard-Synergic
MIG/MAG PMC (option)
MIG/MAG LSC (option)
MIG/MAG Standard-Manual
MMA/SMAW
TIG
Job mode
Select TIG welding process
NOTE! Parameters that have been set on a system component control panel
(e.g. wire feed unit or remote control) might not be able to be changed on the pow-
er source control panel.
Select the "TIG welding" button in the left-hand ribbon
4
3