Mode Setup - Special Display For Jobmaster - Fronius TPS 320i Operating Instructions Manual

Example:
Job group 1: Job no. 3 / 4 / 5
Job no. 6 is not assigned ==> End of job group 1
Job group 2: Job no. 7 / 8 / 9
-
-
-
-
Mode Setup - spe- If the OPT/i GUN Trigger option is present on the power source, the special display for a
cial display for Jobmaster welding torch can be set under "Defaults" – "Mode Setup".
Jobmaster
*
1
2
3
The "Mode Setup" overview appears.
132
When welding starts, the job with the lowest number within the job group is automati-
cally selected.
To change to the job with the next highest number within a job group, press the torch
trigger briefly (less than 0.5 sec.).
To stop welding, press the torch trigger for more than 0.5 sec.
To change to the next job group, press the parameter setting button on the Jobmaster
welding torch for more than 5 seconds.
> 5 s
1
The button is only displayed if the OPT/i GUN Trigger option is present on the pow-
er source.
Select the "Defaults" button in the left-hand ribbon
Select the "System" button in the right-hand ribbon
Select "Mode Setup"
*
2
3