Job Welding - Retrieving A Job - Fronius TPS 320i Operating Instructions Manual

Job welding - re-
trieving a job
1
2
3
A tick (3) appears in the "Job mode" tick box.
Job mode is activated.
In addition, "Job welding" (2) and the data from the most recently retrieved job (1) are dis-
played.
4
NOTE! Before retrieving a job, make sure that the welding system has been in-
stalled and set up for the job.
1
Select the "Welding process" button in the left-hand ribbon
Select the "Process" button in the right-hand ribbon
Select the "Job mode" button
(2)
4
Select "Job welding" in the left-hand ribbon
2
3
(1)
(3)
79