Connections, Switches And Mechanical Components; Tps 320I / 400I / 500I / 600I, Tps 400I Lsc Adv Power Source - Fronius TPS 320i Operating Instructions Manual

Connections, switches and mechanical components

TPS 320i / 400i /
500i / 600i, TPS
400i LSC ADV
power source
(2)
(1)
Front
No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
Function
Mains switch
for switching the power source on and off
Control panel cover
for protecting the control panel
Control panel with display
for operating the power source
(-) Current socket with bayonet latch
for:
- connecting the grounding (earthing) cable during MIG/MAG welding
Blanking cover
reserved for the second (+) current socket option with bayonet latch
Blanking cover
reserved for the second SpeedNet connection socket option
Blanking cover
reserved for the second SpeedNet connection socket option
(+) Current socket with fine-pitch thread (Power Connector)
for:
- connecting the current cable from the interconnecting hosepack during MIG/
MAG welding
SpeedNet connection socket
for connecting the interconnecting hosepack
Ethernet port
Mains cable with strain relief device
Blanking cover
reserved for the second (-) current socket option with bayonet latch
The second (-) current socket is for:
- connecting the interconnecting hosepack during MIG/MAG welding for polar-
ity reversal (e.g. for flux-cored wire welding)
Blanking cover
reserved for the second SpeedNet connection socket option or robot interface
RI FB Inside/i
(10)
(3)
(9)
(8)
(7)
(4)
(5)
(6)
Rear
(11)
(12)
(13)
33