Troubleshooting; No Power; Lcd Screen - Siemens ACUSON Cypress Operator's Manual

Troubleshooting

No Power

If you turn the Cypress system
If you hear the fan and the keyboard is lit, but the screen doesn't light up, call
your Siemens representative.
If the fan doesn't come on and the keyboard is not lit:
Check to make sure the power cable is plugged in.
1.
Check the fuse. See "Fuse Replacement" on page 11-8.
2.

LCD Screen

WARNING It is possible for individual display pixels in the Cypress system
flat-panel
state. This should not interfere with normal operation of the
OFF
system, but could cause confusion if a "stuck" pixel occurs inside
an alphanumeric display. For example, a pixel stuck in the
state might be confused for a decimal point in a measurement,
and a pixel stuck in the
decimal point in a measurement. The system creates a space
around the decimal point separating the whole number from the
decimal — this will help guide you in reading a measurement
even if there is a stuck pixel. If there is any suspicion of this prob-
lem, the multiple display of general measurement results in the
Selection Menu and on the upper right of the imaging screen,
and the multiple display of specific measurements in the Calc
Menus and the Patient Report will allow you to verify the correct
results.
ACUSON Cypress™ Operator's Manual
and it does not boot up properly:
ON
(liquid crystal display) to become fixed in an
LCD
state might obscure the display of a
OFF
Troubleshooting
or
ON
ON
11-7