Connecting The Cypress System To A Network - Siemens ACUSON Cypress Operator's Manual

Connecting the Cypress System to a Network

The Cypress system can be connected to a network if the network option has
been installed on the system. A standard RJ-45 network cable connects to the
port on the right side of the system.
Connecting Cypress System to a Network
FIGURE 40.
Once the Cypress system is connected, complete the
described in "DICOM Setup for Network Transfers" on page 9-8.
Any time that you make changes, click [
connection to the network using the new settings. The Cypress system will
respond with a status message in the Test Result field.
ACUSON Cypress™ Operator's Manual
Connecting the Cypress System to a Network
RJ-45 JACK FOR 10/100 Mbps
ETHERNET CONNECTION
AND STATUS LEDs
DICOM
] and then [
PING VERIFY
setup as
] to confirm the
9-13