Siemens ACUSON Cypress Operator's Manual page 150

Cardiac Calculations
6-6
NOTE Once an averaged result is displayed in a patient report, the averag-
ing function cannot be deactivated.
NOTE If Angle Correction is different for averaged results, then the Angle
Correction display will show three asterisks (***). Note that there is no
averaging of Angle Correction, only the measurements are averaged.
To view and/or edit the individual components of an averaged result, follow
these steps:
Press to open the Selection Menu and then highlight the specific mea-
CALC
1.
surement and click <
Use the Trackball to place the cursor over the averaged result. The list of
2.
individual measurements will open. To edit the list, click <
open the Averaging Edit box. A checkmark next to a measurement indicates
that the number is a part of the averaged result.
Use the Trackball and <
3.
checkmark in the Select All box, places a checkmark in each box. Remove
the checkmark from the Select All box to remove the checkmark from each
box.
To save changes made to the averaging edit box, close the box by clicking
4.
[ ] and then click [
CLOSE
NOTE There is a maximum of 20 measurements per each averaged result.
NOTE Once an averaged result is displayed in a patient report, the averag-
ing function cannot be deactivated.
ACUSON Cypress™ Operator's Manual
> to open the Report Menu.
ENTER
> key to remove and add checkmarks. A
ENTER
] on the Report Menu.
OK
> to
BACKSPACE