Option Card Installation - YASKAWA A1000 Technical Manual

8.4

Option Card Installation

This section provides instructions on installing the option cards listed in
 Prior to Installing the Option
Prior to installing the option, wire the drive, make the necessary connections to the drive terminals, and verify that the
drive functions normally. Refer to the
Table 8.2 below lists the number of option cards that can be connected to the drive and the drive connectors for
connecting those option cards.
Option Card
PG-B3, PG-X3
PG-RT3 , PG-F3
<2> <3> <2> <3>
DO-A3, AO-A3
SI-C3, SI-EM3, SI-EN3, SI-ET3, SI-N3, SI-P3, SI-S3, SI-T3,
SI-W3, AI-A3 , DI-A3
<4> <4>
<1> If only one PG option card is connected to the drive, use the CN5-C connector. If two PG option cards are connected, use both CN5-B and
CN5-C.
<2> These option cards are not available for the application with Motor 2 Selection.
<3> These option cards are not available with models CIMR-A4A0930 and 4A1200.
<4> When AI-A3 and DI-A3 are to be used as monitors, the card can be connected to any of CN5-A, CN5-B or CN5-C. The input status of AI-A3
can then be viewed using U1-21, U1-22, and U1-23, and the input status of DI-A3 can then be viewed using U1-17.
Figure 8.2 shows an exploded view of the drive with the option and related components for reference.
Figure 8.2
YASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical Manual
Table 8.2 for information on wiring and connecting the drive.
Table 8.2 Option Card Installation
L
K
J
I
H
A – Insertion point for CN5
B – Option card
C – Included screws
D – Front cover
E – Digital operator
F – Terminal cover
Figure 8.2 Drive Components with Option
Table 8.1.
Connector
CN5-C (CN5-B)
<1>
CN5-C
CN5-A, B, C
CN5-A
A
B
C
G
G – Removable tabs for wire routing
H – Ground wire
I – Drive grounding terminal (FE)
J – Connector CN5-A
K – Connector CN5-B
L – Connector CN5-C
8.4 Option Card Installation
Number of Cards Possible
2
<1>
1
1
1
D
E
F
8
417