Pressure Pads - Henny Penny 680 KFC Service Manual

Henny Penny
5-11. LID COUNTERWEIGHT (CONT'D)
5-12. PRESSURE PAD
5-10
The cable should now have some slack in it, with the weights
level.
10. Tighten the nut against the bracket, securing the cable.
11. Replace back shroud. Repair is now complete.
The pressure pads are plastic strips that the lid cam presses against
to seal the lid.
1. Raise the lid.
2. Remove the four screws securing the lid cover and remove
cover.
3. Push the lid cam back, off of the pressure pads.
4. Using an Allen wrench, remove large bolt securing the pad.
5. Using a Phillips head screw driver, remove the small screw
securing the pad and remove the broken pad.
If the pressure pad is worn, but not broken, it can be
reversed 180 degrees, and the other end of the pad used.
6. Install new pad in reverse order.
NOTE
NOTE
Model 680
1005