S.bus/S.bus2 Installation - FUTABA 14SG Instruction Manual

S.BUS/S.BUS2 Installation

This set uses the S.BUS/S.BUS2 system. The wiring is as simplified and clean mounting as possible, even
with models that use a large number of servos. In addition, the wings can be quickly installed to the fuselage
without any erroneous wiring by the use of only one simple wire, even when there are a large number of
servos used.
●When using S.BUS/S.BUS2, special settings and mixes in your transmitter may be unnecessary.
●The S.BUS/S.BUS2 servos memorize the number of channels themselves. (Settable with the T14SG)
●The S.BUS/S.BUS2 system and conventional system (receiver conventional CH used) can be mixed.
S.BUS Glider usage example
HUB×4 ( Optional )
S.BUS Aerobatic plane usage example
28 <Before Use>
Receiver: R7008SB
Servo: S3172SV×9 ( Optional )
Throttle servo: BLS173SV ( Optional )
Battery: FR2F1800 ( Optional )
Switch: HSW-L
Receiver: R7008SB
Aileron servo: BLS174SV×2 ( Optional )
HUB×3 ( Optional )
Rudder Servo: BLS175SV×1 ( Optional )
Elevator servo: BLS173SV×2 ( Optional )