Starting And Stopping Test Calls - AudioCodes Mediant 500L User Manual

User's Manual
Parameter
[Test_Call_TestMode]
Test Duration
test-duration
[Test_Call_TestDuration]
Play
play
[Test_Call_Play]
Schedule Interval
schedule-interval
[Test_Call_ScheduleInterval]
66.2

Starting and Stopping Test Calls

The following procedure describes how to start, stop, and restart test calls.

To start, stop, and restart a test call:
1. In the Test Call Rules table, select the required test call entry.
2. From the Action drop-down list, choose the required command:
Version 7.2
the following is reached:

Maximum channels is reached for the test session,
configured by 'Maximum Channels for Session'.

Call duration ('Call Duration') multiplied by calls per second
('Calls per Second').

Test duration expires, configured by 'Test Duration'.

[1] Continuous = The test runs until the configured test duration
is reached. If it reaches the maximum channels configured for
the test session (in the 'Maximum Channels for Session'), it waits
until the configured call duration of a currently established tested
call expires before making the next test call. In this way, the test
session stays within the configured maximum channels.
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Enables and defines the playing of a tone to the answered side of
the call.

[0] Disable

[1] DTMF = (Default) Plays a user-defined DTMF string,
configured in ''Configuring DTMF Tones for Test Calls'' on page
990.

[2] PRT = Plays a non-DTMF tone from the PRT file (Test Call
Tone). For this option, you must load a PRT file to the device
(see ''Prerecorded Tones File'' on page 798).
Note:

To configure the DTMF signaling type (e.g., out-of-band or in-
band) use the 'DTMF Transport Type' parameter (see
''Configuring DTMF Transport Types'' on page 201).

The parameter is applicable only if you configure 'Call Party' to
Caller.
Defines the interval (in minutes) between automatic outgoing test
calls.
The valid value range is 0 to 100000. The default is 0 (i.e.,
scheduling is disabled).
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
987
66. Testing SIP Signaling Calls
Description
Mediant 500L Gateway & E-SBC