Upnp Settings - FLIR QUASAR CP-3211 User And Installation Manual

Configuration and Operation
Note:
You may have to consult with your System Administrator to activate this function.
Traps for SNMP v1/v2/v3
Traps are used by the camera to send messages to a management system for important events or status
changes.
Enable traps – Check this box to activate trap reporting.
·
Trap address – Enter the IP address of the management server.
·
Trap community – Enter the community to use when sending a trap message to the
·
management system. The default value is public.
· Trap Option
Warm start – A warm start SNMP trap signifies that the SNMP device, such as the camera,
·
performs a software reload.
Click Save when complete.
9.3.3.4 UPnP
The System > Network > UPnP screen enables the Universal Plug-and-Play protocol on your network
devices.

UPnP Settings

Enable UPnP – If UPnP is enabled and a camera is discovered on the LAN, the icon of the
·
connected camera appears in My Network Places, allowing direct access, as seen below.
74
UPnP Screen
Direct Access to Camera with UPnP Enabled
CP-3211/CP-4221 User and Installation Guide
September 12, 2016