Table of Contents
Advertisement
Triggered Action
The Administrator can specify alarm actions to be taken when motion is detected. See
Screen. The options are listed as follows:
Enable alarm output – Check this box and select the predefined type of alarm output (low or high)
·
to enable alarm relay when tampering is detected.
Record stream to sd card – Select this box in order to save the alarm-triggered recording to your
·
microSD/SDHC card. Enter the number of seconds for the pre-trigger buffer. Select the first radial
button if you wish to upload for a specified length of time and enter the number of seconds.
Alternatively, select the second radial button to upload while the trigger is active.
Note:
Make sure the local recording (with a microSD/SDHC card) is activated so that this function can
be implemented. See
·
Send alarm message by FTP – Select whether to send an alarm message by FTP when motion is
detected.
Upload image by FTP – Select this box in order to upload an image to a designated FTP site when
·
motion is detected according to various parameters. See Figure:
Note:
Images can be sent by FTP only when MJPEG is selected as the video stream from the
Format
screen.
Specify the FTP address to use from the drop-down menu. Select the number of frames for the pre-
trigger and post-trigger buffers from the drop-down menu of 1-20 frames.
Check the box for Continue image upload if you wish to use this option. To specify the length of
time for the upload, click this radial button and enter the number of seconds. To upload while the
trigger is active, click this radial button. Finally, select the number of frames per second from the
drop-down menu next to Image frequency.
Send HTTP notification – Check this box to send a notification by HTTP. Select the destination
·
HTTP address from the drop-down menu and specify the parameters for event notifications by
motion detection triggered. When an alarm is triggered, the notification will be sent to one of two
specified HTTP servers. See Figure 54: Send HTTP Notification.
September 12, 2016
Record Stream to SD Card
Recording
for further details.
CP-3211/CP-4221 User and Installation Guide
Configuration and Operation
Motion Detection
Upload Image by
FTP.
Video
85
Advertisement
Table of Contents
