Table of Contents
Advertisement
Configuration and Operation
Select the Continue image upload checkbox to upload an image by FTP for a defined period
·
of time or while the trigger is active. Select one of the following options:
·
To specify the length of time for the upload, select Upload for and enter the number of
seconds in the text box.
To upload while the trigger is active, select Upload during trigger active.
·
In the Image Frequency text box, from the drop-down list select the number of frames
per seconds from 1-15 for the upload.
Note:
Make sure that FTP configuration has been completed. See
Send HTTP notification – Select this checkbox to send a notification by HTTP. Select the
·
destination HTTP address from the drop-down menu and specify the parameters for event
notifications by the IO event triggered. When an alarm is triggered, the notification will be sent to
one of two specified HTTP servers. See figure below.
Record Stream to SD Card – Select this box in order to save the alarm-triggered recording to your
·
microSD/SDHC card. Enter the number of seconds for the pre-trigger buffer. Select the first radial
button if you wish to upload for a specified length of time and enter the number of seconds.
Alternatively, select the second radial button to upload while the trigger is active.
Note:
In order to use this function, make sure that local recording with a microSD/SDHC card is
activated and that the NAS is properly configured. See
Send message by E-Mail – Select the checkbox send an alarm message by e-mail when an alarm
·
is triggered. The e-mail address is entered in the
Upload image by E-Mail – Select this checkbox to assign an e-mail address for sending the image
·
captured by a triggered alarm. The e-mail address is entered in the
80
Send HTTP Notification
Record Stream to SD Card
Mail
CP-3211/CP-4221 User and Installation Guide
FTP
Recording
for further details.
screen.
Mail
screen.
for details.
September 12, 2016
Advertisement
Table of Contents
