Table of Contents
Advertisement
Standard or compact wall mounting package contents:
§
M8x12 screw x1
§
Rubber washer 8 x1
§
Spring washer 8 x1
§
Pendant tube washer x1
§
Sponge x2
Tools required:
§
Drill
§
Phillips and flat-head screw drivers
To install the standard or compact wall mount
1. Cut a cable access hole in the wall. Cables can also be threaded through the cable entry board
on the mounting plate if desired.
2. Attach the standard or compact wall mount to the wall using the appropriate screws and screw
anchors (not provided). For outdoor models, attach the waterproof gasket to the wall mount.
3. Thread the cables through the wall mount.
4. After threading the cables, block the entry hole with the supplied sponge to prevent insects
from entering. The sponge can be placed in one of two ways.
5. Thread the cables through the indoor pendant kit or outdoor mount kit and attach the pendant
mount kit to the wall mount using the supplied screws and washers.
6. For outdoor cameras, adjust the waterproof gasket to the joint.
7. Connect the cables to the camera.
8. Secure the camera to the indoor or outdoor mount kit.
September 12, 2016
CP-3211/CP-4221 User and Installation Guide
Installation
35
Advertisement
Table of Contents
